The terrifyingly-dangerous sabot round is capable of liquifying a tank and everything inside of it
By Samantha Franco,
5 hours ago
The sabot round is a type of ammunition used by tanks in armored warfare. This non-explosive, anti-tank round houses a projectile that hits its target with precision and tremendous force. On impact, the chances of survival for the opposing tank crew are minimal, making the sabot round a favored option in combat.
Inner workings of the Sabot round
The sabot round is designed to bridge the gap between a sub-caliber projectile and the tank's barrel, allowing propellant gases to exert force over a larger area instead of solely on the projectile. This construction enables the round to reach a high muzzle velocity, even though its aerodynamics may not perfectly align with the internal ballistics.
As the sabot encases the projectile, it stabilizes it while moving through the barrel. Upon exiting the muzzle, the sabot detaches, allowing the projectile to proceed toward its target—often at speeds nearing 3,500 MPH.
Typically, the projectile consists of a depleted uranium rod engineered to penetrate armor. On impact, it shatters into a spray of metal fragments. The resulting destruction is so severe that one soldier likened it to "liquefying" everything and everyone inside the struck tank or armored vehicle.
Different types of sabot rounds
There are five different types of sabot rounds. The cup sabot supports the base of the projectile and offers structural support around the shaft. It's typically used in small arms ammunition, as well as smoothbore shotgun and muzzleloader projectiles.
The expanding cup sabot is similar to the cup round, in that it's used for rifled small arms. However, when fired, the centrifugal force from the rotation of the projectile causes the segments surrounding it to open up. This introduces more surface area to the surrounding air pressure, releasing it.
The base sabot has a one-piece base that supports the bottom of the projectile, as well as separate pieces that surround the sides and center, breaking away once the round has been fired. This sabot is considered superior to the previous two, as it offers a cleaner and better sabot-projectile separation. However, it's more expensive to produce.
The spindle sabot is typically used in large caliber armor-piercing ammunition. It uses between two and four longitudinal rings with a center section that makes contact with the projectile. The front centers the projectile in the barrel and provides an air scoop to help with its separation from the sabot, while the rear seals the propellant gases with an obturator ring along the outside diameter.
Finally, the ring sabot uses the projectile's rear fins to center it, forming a single ring around the front with an obturator ring to seal the gases. This type of sabot was favored by the Soviet Union, as the steel from which it was constructed could withstand launch accelerations without needing a ramp to support the projectiles.
Multiple generations of sabot round munitions
The M829A1, known as the "Silver Bullet," is an armor-piercing fin-stabilized discarding sabot (APFSDS) round. It has a long-rod, uranium-depleted projectile that's about 1.25 inches wide. Once it hits its target, it punches through armor and typically explodes an enemy tank in what tankers call a "jack in the box" effect.
According to Sofrep , the M829A1 "is widely regarded as the most effective tank-fired (M1 Abrams 120mm main gun) anti-armor weapons in the world. It overwhelmed Iraqi armor during Operation Desert Storm. The M829A1 is a depleted-uranium long-rod kinetic energy penetrator round capable of defeating heavily armored vehicles."
Since then, multiple generations of the round have been developed. The M829A2 improved the structural quality of the uranium-depleted projectile, while the M829A3 made the propellant more efficient to boost muzzle velocity. The M829A4 uses a uranium-depleted projectile with a three-petal composite sabot.
The M1A2 Abrams tank was used throughout Operation Desert Storm and fired 120 mm M829 sabot rounds at enemy armored vehicles; the projectiles took out multiple tanks as they dominated the battlefield. M829 sabot rounds are best used in armored warfare, rather than toward buildings or walls, so were thoroughly employed by the US military throughout the Gulf War.
Comments / 7
Add a Comment
La En
24m ago
Send some to Ukraine
ADCSAWUSNRET
1h ago
My kids a gunner on the Abrams and the sabot round tears everything up.
Get updates delivered to you daily. Free and customizable.
It’s essential to note our commitment to transparency:
Our Terms of Use acknowledge that our services may not always be error-free, and our Community Standards emphasize our discretion in enforcing policies. As a platform hosting over 100,000 pieces of content published daily, we cannot pre-vet content, but we strive to foster a dynamic environment for free expression and robust discourse through safety guardrails of human and AI moderation.